Modify the pass parameters (e.g. max penetration, max manipulator step, etc.) to speed up the forging process. During the software implementation,
all pass parameters will be optimized upon approval from the customer. Some parameters are material dependent; these will be provided in the material table.
This means that the parameters normally do not have to be changed for standard forgings. Nevertheless, for special forgings you are
able to modify the parameters according to the requirements.

Optimize pass parameters

The Open-Die Forging Software will automatically calculate a sequence of operations that are necessary to get the desired forge piece.
This forging sequence will include operations like "Get material", "Heating in the furnace", "Upsetting", "Forging with flat dies", "Turn ingot",
"Forging with swage dies" and so on. The automatically calculated forging sequence will consider the dimensions of the segments, the profiles of the segments,
the necessary reduction of the forge piece, the temperature of the forge piece, etc. You are able to modify the calculated schedules manually afterwards if necessary.

Check and modify the forge schedule

For every forging operation, the Open-Die Forging Software calculates the pass schedules that can be downloaded into the press controls.
The pass schedule shows all of the important information for the forging process: press force, number of strokes, manipulator step, dimensions, etc.
For each pass schedule, the software calculates the total forging time and the final temperature.

The pass schedule is calculated according to the law of Tomlinson and Stringer and includes some optimizations based on our experience.

See the pass schedules

The whole forging process can be simulated in 3D. You can rotate the forge piece, and you can even zoom in and out.
This makes complicated forging steps descriptive and comprehensible.

Simulate the forging process